How to Mix and use Melanotan 2

Even the most quality product can appear ineffective if not used properly. That’s why it’s crucial to carefully read information, we have developed a thorough guide on how to use Melanotan 2 to help you get the most out of it and avoid unwanted side-effects. Please, read it carefully and any questions please feel free to contact us. As per our terms and conditions this is for information purposes only.

How to mix MT2 vials.

The product comes in two separate flasks. Their contents should be combined to get one solution. Mixing Melanotan 2 does not take much trouble. However, there are certain rules to follow to ensure the substance works appropriately. Please, take these steps to reap maximum rewards from your treatment:

pull off the yellow cap from Melanotan 2 injection vial see PICS 2 below
clean the surfaces of the vials with an alcohol wipe which are included with the kits.
clean the surfaces of the water with the alcohol wipe
take the syringe out of the packaging and push the needle part into the side of the water and fill the syringe with water 1 full syringe is 1ml of water (some people add another quarter of water to the solution as this may reduce the initial side effects)*. SEE PICS 1 Below
slowly inject water into the vial with MT2, pushing the needle through the centre of the grey cap which was below the yellow cap (there is a circle raised top of the grey cap use this as a guide for the centre, if you feel resistance you may need to place the needle slightly off centre) see PICS 2 below
Once the needle is in the vial try to aim so the water goes on the side of the vial and not directly onto the MT2. If you are adding another quarter of a syringe 0.25ml repeat the step above. FOR MIXING NASAL REPEAT THIS STEP USING 2 FULL SYRINGES OF WATER PER VIAL.
carefully roll the Melanotan 2 vials between your fingers to help the Melanotan 2 to dissolve into a solution ( NEVER SHAKE THE VIAL)
once the mixture is ready, put it into the fridge standing upright until you are ready to use it

Please note: Water once open cannot be kept, any remaining water should be discarded (put in the bin).

For mixing NASAL SPRAY, use the steps above putting 2 full syringes of water per vial, draw the solution out of both vials and place into the nasal spray bottle (gently).

The mixed Melanotan solution can be stored in a fridge for up to six months (keep vials upright). The shelf life of the unmixed product is about 12 months in cool dark place.

*People with a low tolerance level to reduce tanning injection side effects may wish to either micro dose 0.05ml (20th of a syringe) for the first 3-4 days or add double the amount of water when mixing the solution.

What type of syringe, should you use? if you buy a kit the correct syringes will be enclosed, however if you decide to buy syringes from another store you need an ultra fine 1ml fixed needle syringe which needs to be either 29g or 30g (g measure the thickness of the needle part). See the pics below for the amount of water per vial depending on the type of syringe you are using.

ML type Syringe water amounts for mixing :

PICS 1

Insert the needle into the side of the water

ml type Syringe water amounts for mixing

+ =1.25ml

IU type Syringe water amounts for mixing:

+ =125iu (which equals 1.25ml)

FOR NASAL SPRAY MIX 2 FULL SYRINGES OF WATER PER VIAL

PICS 2

]

START SHOPPING

How to use Melanotan 2 tanning injections

If you’re ready to give yourself a tanning shot, make sure you have the mixed MT2 solution, and your syringe and alcohol swabs are at hand. The injection process can also be completed in six steps:

Take the mixed MT2 vial. Push the needle part of the syringe through the grey cap centre (like you did when filling the vial with water).
Pull back on the plunger to fill the syringe with 0.1ml ( of the mixed solution and withdraw the needle the first main marker which is around 10th of a syringe)* SEE PIC BELOW
Locate the shot site in your belly area (a few centimetres away from the navel) and clean it with a swab (see pic*).
Pinch / nip 1-2 cm of skin you tummy fat tissue about four fingers distance from your belly button, this will help you not to go too deep.
Insert the needle into the area you hold at a 90-degree angle (see pic **). Do not withdraw it until you administer the entire 0.1ml of the solution in the syringe. IMPORTANT: If you are slim and have little fatty tissue you may need to insert the needle at a 45 degree angle. You should not go through the fatty layer (subcutaneous layer) of you skin.

You’ve now taken your first Mt2 jab.

*People with a low tolerance level may wish to either micro dose 0.05ml (20th of a syringe) for the first 3-4 days or add double the amount of water when mixing the solution.

The right Melanotan 2 dosage revealed

If you want to achieve the best results, it makes sense to use Melanotan regularly. However, it should be no more than once a day.

Our suggestion is take maximum 0,1ml (10th of a syringe) every night before going to bed this help reduce the feelings of the initial side effects. After around the fourth injection you will notice your freckles darken (very pale people will see this in some cases several days later), once the happens the solution is active in your system and you need some UV exposure to kick start Melanotan 2’s action. Continue with the jabs every night and UV exposure every other day until you get the colour you desire. Once the desired result is achieved, you can reduce MT2 jabs use to one dose a week and sunbath less frequently.

We are aware people opinions differ on this, and indeed online there are many different suggestions on dosage, how often, etc. All the guys in the office have used MT for the past 10+ years and as normal we only make suggestions from our own personal experiences and indeed what has worked for us, not from what we have read elsewhere…

Dosage amount maximum in ml 0.1ml